@2023-2025 Kaamos Tech Ltd
Showing all 2 results
-
SPDIF TX v2 Dual Mono
£59.00 Ex. VATPCM I2S to S/PDIF digital audio converter with I2S serial audio input and BNC, Toslink, and AES/EBU outputs.
Product options:
- Channel configuration:
- Dual Mono for 2x ADC AK5572 Mono boards.
Stereo for any other use.See a new version. This listing is only for the remaining Dual Mono units.
- Oscillator circuit (soldering included):
- Most use cases are I2S Slave using existing MCLK from the I2S source, not needing this circuit.
- See full product description below and SPDIF TX guide.
- “Yes, with U.FL input”
- U.FL input and three buffered U.FL outputs to split and buffer existing MCLK.
- “Yes, with standard 24.576MHz OSC”
- Connor Winfield 24.576MHz or similar oscillator and three buffered U.FL outputs.
- “Yes, without source (use your own or buy CCHD)”
- Three buffered U.FL outputs but no oscillator. Use your own (check footprint!) or buy Crystek CCHD-957 from us.
- Most use cases are I2S Slave using existing MCLK from the I2S source, not needing this circuit.
The board is delivered tested and all required SMD components soldered down. Connectors and headers are included, and you can choose to get them soldered down or not.
Additionally, we recommend following addon products:
- U.FL cables to connect digital audio signals between Kaamos boards.
- 2-pin power cables; you can also solder wires on power connector placeholder.
Select options This product has multiple variants. The options may be chosen on the product page - Channel configuration:
-
SPDIF TX v3
£55.00 Ex. VATPCM I2S to S/PDIF digital audio converter with I2S serial audio input and RCA/BNC, Toslink, and XLR outputs.
Product options:
- S/PDIF connector; coaxial output connector type:
- RCA.
- BNC (75 ohm).
- Oscillator:
- “No oscillator”.
- Most use cases are I2S Slave using existing MCLK from the I2S source, not needing an oscillator.
- “Yes, with standard 24.576MHz OSC”.
- Connor Winfield 24.576MHz or similar oscillator and three buffered U.FL outputs.
- “Yes, with Crystek CCHD (sold separately)”.
- This is to note you want us to solder a Crystek CCHD-957 oscillator. It is not included, you need to purchase it separately.
- “No oscillator”.
See more information on the oscillator selection in the full description below.
The board is delivered fully assembled and tested, as shown in the photos.
Additionally, we recommend the following addon products:
- U.FL cables to connect digital audio signals between Kaamos boards.
- 2-pin Molex power cables
Select options This product has multiple variants. The options may be chosen on the product page - S/PDIF connector; coaxial output connector type: